Operating instructions

12
Stamping
Stamping will be triggered by pressing the red trigger, which is located
in the grip.
Depending on the impression selected, the impression will have one or
two lines. The position of the two lines, relative to the base of the stamp,
can be seen in the illustration below.
• Stamping may be protected by a password. In that case
the correct password must first be entered.
To block stamping again, press [ MODE ] repeatedly
until 'CLOSE' appears in the menu bar.
Pressing [ CLOSE ] will block stamping
• With longer stamp breaks, jetStamp should be placed
into the base station to ensure that the jets of the
ink cartridge stay on up state
The ink in the ink cartridge is harmful!
Never hold jetStamp gainst a person’s face!
Stamping is not possible under the following circumstances:
• When the battery is discharged - the display shows
“EMPTY BATTERY NO IMPRINT POSSIBLE”
¥ In Setup or Setting mode
• When jetStamp is in the charging station
•
Printing is blocked - the display shows “IMPRINT BLOCKED”
The blockade can be released by pressing [ QUIT ]
(see also page 21, menu item 'BLOCK IMPRINT')
max. width
of both print lines
i
Note
first print line
second print line
MSL03 11. 07. 06 09:55
USED 18. 07. 06 09:55