Operating instructions

8
Setting the date and time
• Date and time can only be set if a selected imprint
contains at least the date (see pages 13 ... 17)
• The device disposes of dual input of time and date,
designated as date 1 and date 2
Date 1 will be used for the internal stored imprints
Date 2 will be used exclusively in 785. In this case,
date 1 and date 2 are used for special
stamp pictures, stored on the chip card
Setting:
Press [ time ] : The display shows MInUTE 1
The date and time appear and the minutes are flashing.
If PASS 0000 appears in the display, then date and time setting
is protected by a password. Enter the password via the keys
[ set ] and [ mode ] (see also page 25, ‘Password clock’)
Press [ line ] to switch between Date 1 and Date 2 .
The display changes corresponding between
MInUTE 1 and MInUTE 2
Press [ set ] repeatedly until desired minutes appear
Press the key [ mode ] : The hour display flashes.
Set the value of hours with [ set ] as described above
Press the key [ mode ] for successively calling the year,
month and day and set in each case with the key [ set ]
Press [ time ] to exit the date and time settings.
The set imprint appears on the display.
i
Note