Operating instructions

Accumulator

The accumulator saves data at power failure and is also sufficient

for a limited number of prints (see page 38, ‘Technical data’).

Meaning of the accumulator symbol in the display:

• Device is connected to mains:

is not displayed : Accumulator is fully charged.

is flashing : With constantly frequenting of

(by high frequents of printing) printouts, it is possible to

trigger up to 100 prints.

Following the display

CHArGE bAT will appear.

Display CHArGE bAT : Accumulator is charging,

device not yet ready for use.

The device is ready again in

approx. 15 minutes. The

accumulator is fully recharged

after approx. 20 hours.

• Device is not connected to mains:

is displayed :

Unit is in accumulator operation

is flashing : Accumulator is close to be

discharged. About 100 prints

are possible, subsequent the

display EMPTY bAT will

appear.

Display shows EMPTY bAT Accumulator is discharged.

or no display: Stamping is not possible.

Connect the device to the

mains, after that the display

CHArGE bAT will appear.

Note