Operating instructions

Key function (printing disable)

After activating the chip card function (see page 22, chip card on)

printing is only possible with an inserted chip card.

If the chip card is missing, InSErT CHIPCArd will be displayed.

Operator’s identification on the chip card

An operator’s identification stored on the chip card can be

printed at the end of an imprint. This operator’s ID can be

combined with a standard imprint, stored in the device

or with a customer imprint, stored on the chip card.

First, the chip card function must be active (see page 22)

and the desired number of an imprint must be entered.

After inserting the chip card, the printing process can be

triggered.

The maximum printing width is 60 mm, so the operator’s

identification cannot be included with all imprints.

(see pages 13 ... 17)

Imprint example:

Printing of the first print line (Line 1) from chip card

Before printing the Line1 stored on the chip card,

the chip card function must be active (see page 22) and

imprint no. 00 must be set (see page 13)

Insert the chip card. Subsequent the imprint

appears in the display and the device is ready to print

the first text line

operator’s identification

123456

29.05.08 09:40

BSP

Note