Operating instructions

21
Press [ n/r ] : The display shows e g rEP 01 .
If PASS 0000 appears in the display, this setting is protected by a
password. Enter the password via [ set ] and [ mode ]
To scroll through available menu items, press repeatedly [ line ] .
The choose depends on the set stamp picture.
rEP 01 = setting of repetition factor (00 ... 99)
(00 = no increment count of numberer)
P- TEXT =
setting of pre-text (see also page 18 + 19)
AUT nr 1 000000 = setting value of numberer 1
AUT nr 2 000000 = setting value of numberer 2
(only Model 785 and 787 with chip card)
FIX nr 1 000000 = setting fixed valuation of numberer 1
FIX nr 2 000000 = setting fixed valuation of numberer 2
TExT (01 ... 12) =
setting the contents of a text field 01 ... 12
After selection of a menu, right-hand of it the actual value is displayed.
The flashing position can be set by pressing [ set ]
The remaining input-digits can be called by pressing [ mode ]
and they can be set with [ set ]
Note: By setting the character the corresponding digit can
be used as placeholder
Press key [ n/r ] to quit the input and leave this menu.
The set imprint reappears in the display and Multi Printer
is ready to print
Additional functions of the numberer
Press [ fkt ] and simultaneously [ mode ] to reset
the numberer to zero with retaining the repetition factor (rep)
Press [ fkt ] and simultaneously [ fkt ] to interrupt
the repetition (rep) and print the next number.
The numberer increments to one number.
Setting of Numberer / Number / Text