Operating instructions

The Numberer enables the ongoing numbering of imprints into

corresponding fields, indicated as num at the different,

stored imprints (see pages 13 ... 17)

The device disposes of dual numberer:

Numberer 1 6 or 8 characters (depending on set imprint)

will be used for the stored, device internal imprints

Numberer 2 (

1 ... 8 characters ) is used exclusive in Mod. 785 + 787

for special imprints, stored on the chip card

The numbering field can include following settings:

• Setting of the starting number

(Setting see page 21, AUT nr 1 respectively AUT nr 2)

• Setting of repetition (rep) enables the stamping of a constant

number with the set repetition factor (0 ... 99) . This is displayed

at the left (excepting the imprints 11 ... 13)

• Incremental printing of an adjustable minimal value up to a

maximal value (setting see page 23, Mode n1 / n2 )

• Decreasing printing of an adjustable maximal value to an

adjustable minimal value (setting see page 23, Mode n1 / n2 )

• Skip of numberer (adjustable 0 ... 99 )

(setting see page 23 / 24, Skip n1 and Skip n2)

• Minimal value of numberer stored by pressing [ fkt ] and

[ set ] . Symbol appears behind AUT nr 1 or AUT nr 2

Repeated pressing the keys shows the stored value

• Maximal value of numberer stored by pressing [ fkt ] and

[ mode ] . Symbol appears behind AUT nr 1 or AUT nr 2

Repeated pressing the key shows the stored value

• Reset stored values of numberer (min. and max.)

Reset will be executed by pressing keys [ fkt ] and [ n/r ]

The symbols and disappear

Functional description of the Numberer (num)

Note