Operating instructions
12
Setting the imprints
Altogether there are 39 standard imprints stored in the
device. An overview of the stored imprints is shown
on the pages 13 ... 17. To select a desired imprint,
enter its corresponding number as follows:
Press the key [ mode ] for at least 5 seconds until
SETTinGS appears in the display
If PASS 0000 appears, the settings are protected by a password.
Enter the password via the keys [ set ] and [ mode ]
Press [ line ] the display shows ChiPCArd
Press [ mode ] the display shows ST PiCTUrE
Press [ line ] the number of the imprint is
displayed with one digit flashing
Entering the number: Press [ set ] repeatedly, until
the desired tens digit number is shown
Press [ mode ] the next digit is flashing
Press [ set ]
repeatedly until the desired digit is shown
Press [ n/r ] repeatedly, until the imprint
appears in the display
By setting imprint 00 (possible only at Mod. 785 and 787)
the device prints exclusively data stored on a chip card.
(see also page 28, ‘Additional functions in Model 785 + 787’)
Examples of imprint no. 38 with explanations:
pre-text number date time
number date time operator’s identification
from chip card
QUIT.
123456
29.05.08 09:40
123456
29.05.08 09:40
BSP
i
Note
i
Note