User`s guide

Page 8
Set Up Instructions
To set up the TONO-PEN XL for operation, follow the instructions listed below:
Remove all protective packaging materials. Remove and discard the
desiccant.
Carefully remove the tonometer and accessories from the case.
Check for missing items.
Visually check the instrument and accessories for damage.
Remove the Ocu-Film Tip Cover shipped with the TONO-PEN.
Notify Reichert Customer Service immediately if any components are missing
or damaged.
Install the batteries in the battery compartment (see page 9).
Perform the Calibration Procedure (see page 11).
Slide a new Ocu-Film Tip Cover over the TONO-PEN XL unit’s stainless steel
p
robe until the Ocu-Film ridge is seated in the groove (see Figure 2). The
Ocu-Film Tip Cover should t over the probe tip (see Figure 3), without being
too tight. Proper t makes contact with the transducer surface (probe post),
but still has pleats along the side of the transducer head assembly.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Setup
Probe Post
Groove
Probe Tip
Operator’s Button LCD
Battery Compartment
Figure 2 TONO-PEN XL Top and Side Views