Product Manual

6
TROUBLE SHOOTING GUIDE
Problem Cause Solution
Radio will not power up No power to yellow BATTERY
wire or blown 5A main fuse.
Check for both ACC &
BATTERY voltage with
Multi-meter, check all fuses.
No sound Speakers not connected; speakers
connected with bad splices;
Speakers shorted to ground;
speaker load is not within 4-8 Ω.
Connect speakers to harness;
check all spliced wires; verify
speakers not shorted to chassis;
verify total speaker impedance.
Check volume level.
Cannot tune radio stations The antenna cable is not connected.
The signal is too weak. The radio
is in the wrong frequency steps.
Connect the antenna cable.
Check the frequency spacing in
the radio’s SERVICE menu.
ELECTRICAL CONNECTIONS
Follow this easy wiring diagram when installing Radio and Speakers.
Warning:
*This radio is designed for 12/24V DC Negative Ground Systems only.
7
Radio
Din Collar
Dash Opening Dimensions
7
1
8
in.
2
3
32
in.
Din Collar
Bend tabs both top
and bottom of Din Collar
to secure
Dash
**NOTE: THE RADIO’S YELLOW BATTERY WIRE MUST BE
CONNECTED FOR OPERATION.
REQUIRED RADIO DIMENSIONS
Verify the radio will fit by following the suggested dimensions below.
INSTALLING THE RADIO
1. Place the DIN collar into the dash opening. Bend the tabs outward as shown on
the drawing below to lock into place.
2. Connect to the radio’s harness and antenna jack. Verify clearance; then gently
insert the radio into the DIN Collar until both sides lock
.