Product Manual

8
3. If additional support is needed, add the included support bracket, and secure it to the
vehicle. Secure the opposite end to the radio’s rear chassis using one of the 5mm
screws provided.
4. To remove the radio, loosen the support bracket screw if used. Insert the two
release keys on either sides of the radio and pull the radio out.
5
8) Mode Button
Press this button to navigate between modes AUX —TUNER.
9) Scan Button
Press this button to automatically preview radios station for 5 seconds.
10) Auxiliary Input Jack
The unit is equipped with a front panel 3.5mm auxiliary input so you can connect your
external portable audio player or portable satellite radio receiver.
*It may be necessary to adjust the volume level of your portable devise to achieve an
optimal volume level.
Weather Band Mode
NOAA National Weather Radio Broadcasts from over 380 Locations throughout
the U.S. on seven VHF/FM frequencies. Tune to receive continuous weather
information 24 hours a day on one of the following frequencies.
Press preset 1 to select weather band channel 1 - 162.400MHZ
Press preset 2 to select weather band channel 2 - 162.425MHZ
Press preset 3 to select weather band channel 3 - 162.450MHZ
Press preset 4 to select weather band channel 4 - 162.475MHZ
Press preset 5 to select weather band channel 5 - 162.500MHZ
Press preset 6 to select weather band channel 6 - 162.525MHZ
**Press SEEK UP/DOWN to select weather band channel 7 - 162.550 MHz
SERVICE MENU
From radio mode, Press and hold preset 1 for 2 seconds, Press and hold preset 3
for 2 seconds, Press and hold VOL/SEL for 2 seconds, the display will show:
 US/EU rotate VOL/SEL to choose from US or EURO frequency steps, press
VOL/SEL to confirm.
 AM ON/OFF rotate VOL/SEL to enable or disable the AM Band option, press
VOL/SEL to confirm.
 AUX ON/OFF rotate VOL/SEL to enable or disable the AUX MODE option,
press VOL/SEL to confirm.
 ANY ON/OFF rotate VOL/SEL to enable or disable the ANY button power on
option, press VOL/SEL to confirm.
 BAL ON/OFF rotate VOL/SEL to enable or disable the Balance Control option,
in the tone menu, press VOL/SEL to confirm.
 CLK ON/OFF rotate VOL/SEL to enable or disable the CLOCK display by
default option, press VOL/SEL to confirm.
 Radio Firmware version X.X
To save and exit SERVICE mode, press and hold the VOL/SEL button. Menu will
exit automatically after 5 continuous seconds without any selections.