Product Manual

4
OPERATION
1) Power On/Off Button
Press the Power Button to turn ON or OFF the unit.
Note: Radio can also be powered on by pressing any front button.
2) Volume/Select Knob
Rotate the knob left or right to change the volume level.
Press the knob to select one of the following functions:
VOL---BASS---TREB---BAL
Upon choosing the function, rotate the knob to adjust the desired setting.
PLEASE NOTE: If the Volume/Select Knob has not been adjusted for 5 seconds it will
automatically revert back to volume function.
3) Auto Store / Preset Scan Button
Press and hold this button for 2 seconds to auto program available stations into the
preset memory buttons. This function will erase previous memorized stations and store
the newly searched stations. Once completed, the radio will scan for 5 seconds through
each of the preset stations of either the AM or FM band and stop.
Press this button momentarily to scan preset stations.
4) Preset Memory/Recall Buttons
Press these buttons momentarily to select the preset stations.
Press and holding a button will preset the current station to the button being pressed.
**Preset buttons are Pre-assigned Frequencies in Weather Band Mode.
5) Band Selector Button
Press this button to change radio bands as follows:
FM1—FM2—FM3—AM1—AM2 —WB
6) Tune /Seek Buttons
Under Radio mode, press the desired button momentarily to manually tune a station
moving upward or downward. Press and hold a button and the radio will automatically
seek the next available radio station. These buttons also function as Weather Band
Channel 7 (162.550 MHz) access. Under weather band mode, pressing these buttons
will select weather band channels 1-7.
7) Clock Button
Press this button to change between Clock and Mode Information display.
Setting the Time:
With the radio’s power ON, press this button momentarily to display the time. Next,
press and hold this button until the hour display begins to flash. Rotate Volume/Select
Knob to adjust the hour. Press the DISP button again, and the minute display will flash.
Rotate VOL/SEL Knob to adjust the minute. Press the VOL/SEL button to save the
time on the LCD.
9
SPECIFICATIONS
AUDIO SECTION
Power supply voltage (negative ground) ……………….………(10V - 30V allowable)
Standby Current…...………………………..…………..………………………...<6mA
Max Current Consumption……….……………………….……….….………. …..2.5A
Speaker impedance …………………….……………….……… 4-8 Ohms per channel
POWER OUTPUT
Continuous Output into 4Ω, 1KHz at 10% THD/12V…… …..…..…..……..2 x 8Watts
Continuous Output into 4Ω, 1KHz at 10% THD/24V…… …..…..………..2 x 21Watts
Maximum Power Output …………………………………..….….....11W×2 (at 14.4V)
Maximum Power Output …………………………………..….….....50W×2 (at 30.0V)
FM TUNER
Range ……………………………………………………..….(USA) 87.5 – 107.9 MHz
(EUR) 87.50 – 108.00 MHz
Usable Sensitivity (S/N = 30dB)……………………………...7.34dBf.(0.6uV/75ohms)
Signal to noise ratio ………………………………….…………………...58dB (Mono)
Stereo separation (@ 1K Hz) ………………………….………...……….……..…42dB
AM TUNER
Range …………………………………………………..…….…(USA)530 – 1,710 kHz
(EUR) 522 – 1,620 kHz
Usable Sensitivity (S/N = 20dB)………………………..…………....23dBuV (14.4uV)
Signal to noise ratio (LEVEL60dbuV)…….……………….......………………... 60 dB
WEATHER BAND TUNER
Range …………………………………………………..……….162.400 –162.550MHz
Usable Sensitivity (S/N = 20dB)……………………..…………………0.7uV(-9dBuV)
Signal to noise ratio (LEVEL40dbuV)…….…………………...………………….42dB
AUXILIARY INPUT SPECIFICATIONS
Input Voltage Maximum Voltage…………………………………………………...1.2V
Input impedance…………………………………………………………………..10KΩ
DIMENSIONS
Chassis (W x H x D) …………………………………....………….. 178 x 50 x 72 mm
Nosepiece (W x H x D) ……………………………….….…………. 188 x 58 x 13mm
Weight ………………………………………………….…………………….…. 15.8oz
WARNING: When installing, make sure the rear chassis has proper clearance
from obstructions as the chassis heatsink may become hot
*Due to continuous product improvement, specifications and design are subject to
change without notice.