Instructions / Assembly

Any problems or questions call Regency Oce Furniture at 1-866-816-9822

IMPORTANT NOTICE:

Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.

Check to be sure that you have all parts and hardware.

Remove all wrapping materials, including staples & packing straps before you start to assemble.

Do not tighten all screws/bolts until completely assembled.

Keep all hardware and packaging out of reach of children.

Organize your parts and hardware before you begin.

Impresa Swivel Recliner & Ottoman • N1701 • INSTRUCTIONS

Parts :

D: Cylinder

Quantity: 1

A: Seat Bottom

Quantity: 1

B: Back

Quantity: 1

Hardware :

G: Ottoman Top

Quantity: 1

F: Ottoman Base

Quantity: 1

E: Arms

Quantity: 2

H: Ottoman

Stem

Quantity: 1

I: 3” Bolt M: Nut

N: Knob & Washer

Quantity: 2

J: 2” Bolt

Quantity: 4

K: 1 3/16” Bolt

L: 13/16” Bolt

Quantity: 2 Quantity: 2

Quantity: 1

C: Chair Base

PAGE 1
Impresa Swivel Recliner & Ottoman • N1701 • INSTRUCTIONS Organize your parts and hardware before you begin.
PAGE 2
Impresa Swivel Recliner & Ottoman • N1701 • INSTRUCTIONS STEP 1: Place Cylinder(D) into Chair Base(C). STEP 2: Place Seat Bottom(A) on to Cylinder(D) by lining up hole with cylinder and pressing down. D A C D STEP 3A: Align the Seat Bottom(A) with the Back(B) noting where bolts will go through the frame, and into the Back. STEP 4A: Recline the Back(B) until the fasteners on the Seat Bottom(A) and Back(B) overlap.
PAGE 3
Impresa Swivel Recliner & Ottoman • N1701 • INSTRUCTIONS STEP 5: Install the Knob & Washer(N) into the frame of the Seat Bottom(A), allowing the seat to recline. STEP 6: Attach Arms(E) to Seat Bottom(A) frame using two 2” Bolts(J) per arm. E K A N J J A Front NOTE: The front should be indicated on each Arm(E). the incorrect arm will not work on the wrong side. E J STEP 7A: Attach the Ottoman Stem(H) to the underside of the Ottoman Top(G) using four 13/16” Bolts(L).