Instructions / Assembly

Parts:

Quantity: 2

F: Thumb

Screws

E: Flat Bracket

C: Stringer D: EClip Bracket

IMPORTANT NOTICE:

Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.

Check to be sure that you have all parts and hardware.

Remove all wrapping materials, including staples & packing straps before you start to assemble.

Keep all hardware parts and packaging out of reach of children.

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

B: Tabletop

Legacy Racetrack Conference Table • INSTRUCTIONS

(LCTRT7135, LCTRT9543, LCTRT12047)

Organize your parts. You may need a rubber mallet.

G: Corner Bracket

Hardware:

Quantity: 2

Quantity: 1

Quantity: 2

Quantity: 10

Quantity: 1

A: Legs

H: DPEL

PAGE 1
Legacy Racetrack Conference Table • INSTRUCTIONS (LCTRT7135, LCTRT9543, LCTRT12047) Organize your parts. You may need a rubber mallet. B H A A C Hardware: Parts: A: Legs B: Tabletop E: Flat Bracket F: Thumb Screws Quantity: 2 G: Corner Bracket Quantity: 2 Quantity: 2 C: Stringer Quantity: 2 H: DPEL D: EClip Bracket Quantity: 1 Quantity: 1 Quantity: 2 IMPORTANT NOTICE: Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
PAGE 2
Legacy Racetrack Conference Table • INSTRUCTIONS (LCTRT7135, LCTRT9543, LCTRT12047) Organize your parts. You may need a rubber mallet. STEP 1a: Attach Stringer (C) to one of the Legs (A) by lining up the Eclip with its corresponding holes, and sliding down into place (see figure 1). Please Note: The interior of Legs(A) have two EClip attachment holes and the exterior has just one.
PAGE 3
Legacy Racetrack Conference Table • INSTRUCTIONS (LCTRT7135, LCTRT9543, LCTRT12047) Organize your parts. You may need a rubber mallet. STEP 3: Attach Tabletops (B) to assembled base by lining up pre-drilled holes on bottom with the EClips on Legs (A). Then slide Tabletops (B) into place from opposite sides. Please note: fit will be snug. You may need a rubber mallet to tap into place B B STEP 4a: From underneath the table, lock both Sash Locks on Tabletops (B) (see figure 3).