Use and Care Manual

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
LDS7135, LDSBF7135, VDS7135, VDSBF7135 - INSTRUCTIONS
Step 2:
Check Cams
to make sure
that the arrow
is pointing
toward the
hole in the
side as shown.
A
Organize your parts and hardware.
Hardware should include:
A) 5 L-Brackets
B) 13 Cam Pins
C) 13 Cam Covers
D) 30 Screws
NOTE: 13 Cams (shown in
Step 2) should already be
placed in wooden parts.
Tools Required: Phillips Screwdriver
B
C D
Wooden Components
include:
E) 1 Left Leg
F) 1 Right Leg
G) 1 Desk Top
H) 1 Modesty Panel
NOTE: Desk top
for LDSBF7135 and
VDSBF7135 will have
bowed edge.
E G
HF
Step 1: Thread Cam Pins (B) into
Small holes, 3 per each Leg (E, F)
and 7 for the Desk Top (G), with
screwdriver.
Step 3: Insert Pins (B) on
Legs (E, F) into holes in Modesty
Panel (H); rotate Cams clockwise to
lock in place.
Step 4: Insert Pins (B) on Top (G)
into holes in Modesty Panel (H) and
Legs (E, F); rotate Cams clockwise to
lock in place.
Step 5: Attach 3 Brackets (A) as
shown, using 6 Screws (D) for each.
Step 6: If peds will not be used with
this desk shell, attach remaining 2
Brackets (A) as shown for additional
stability.
IMPORTANT NOTE: If only one ped will be used with this desk shell, attach Bracket (A) to the side of the desk without
the ped as shown in Step 6.
Step 7: Place
Caps (C) over
Cams.
This completes desk shell
assembly. If attaching
peds to the desk shell,
proceed to instructions
for how to attach your ped
before turning desk shell
upright.