Instructions / Assembly

Step 3: Insert the rod(E) through the

hole in the base (B) and attach nut to

exposed rod end under base bottom.

STEP 3: Place the exposed end of the

metal rod (E) through the hole in the

spider (D)

STEP 2: Remove the nut from the bottom

of the rod (E) and set aside.

A. Square Top

A2. Round Top

B. Large Base

C. Cylinder

D. Spider

E. Rod

F. Foot (4)

G. Screws (8)

STEP 1: Screw 4 feet (F) into base (B) leg

ends.

STEP 4: Next place the exposed

metal rod (E) with Spider (D) through

the cylinder (C)

The product

should now look

like the example

to the right.

Organize your parts. You will need a phillips head screw driver, crescent wrench, tape measure and pencil, drill(optional).

Two people are required for assembly.

Square/Round Table Top INSTRUCTIONS

(MTBX22, MTBX30, MTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848, TTRD30, TTRD36, TTRD42, TTRD48)

PAGE 1
Square/Round Table Top INSTRUCTIONS (MTBX22, MTBX30, MTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848, TTRD30, TTRD36, TTRD42, TTRD48) Organize your parts. You will need a phillips head screw driver, crescent wrench, tape measure and pencil, drill(optional). Two people are required for assembly. A A2 B C E F G D STEP 1: Screw 4 feet (F) into base (B) leg ends. STEP 2: Remove the nut from the bottom of the rod (E) and set aside.
PAGE 2
Step 6: Prepare your Template (INCLUDED) by adhereing both template pages to one another on the dashed line. STEP 7: Turn Table Upside down. According to your table top(Square or Round) draw 2 diagonal lines across the table as shown below. STEP 8: Place dot 1, located on the template, directly over the crossing lines.
PAGE 3
STEP 9: Once aligned, mark template dots 2,3,4,5 on table bottom. 1 4 2 3 1 4 5 STEP 10: Place table top (A,A2) flat on the floor and set the completed base over the center. 2 3 5 STEP 11: Line Up the marks made on table from step 9 with the holes on the spider arms. Attach using 8 Screws(G) and flip table over. 2 3 1 4 2 3 5 1 1 4 4 2 3 5 5 IMPORTANT NOTICE Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
PAGE 4
-The Outside dots are for 48” Table tops and MTBX 36 X-Bases. -The Inside dots are for 30”, 36” and 42” Table tops and MTBX 22 & 30 X-Bases. 1 LINE UP TOP EDGE OF SECOND SHEET HERE.
PAGE 5
4 5