Use and Care Manual

9476 • Assembly Instructions for the 9476 Side Chair
ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE
Any problems or questions? Call Regency at 1-866-816-9822 or email [e-mail]
STEP 7: Take note of Seat (G) orientation before
placing it onto the Slats (I). There is a sticker that
claries which side is the front of the seat.
STEP 9: Insert Screws (C) into predrilled holes in
bottom of each Slat (I) and tighten.
The completed assembly should look like this.
(Colors may vary based on purchased nsh)
STEP 8: Once the correct orientation is found,
place the Seat (G) onto the chair assembly with the
front side facing away from the seat back.
PLACE
DOWN