Use and Care Manual

9476 • Assembly Instructions for the 9476 Side Chair
ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE
Any problems or questions? Call Regency at 1-866-816-9822 or email [e-mail]
STEP 1: Insert the Small Slat (I) into angled part of
either Leg (F), with holes facing inwards.
Ensure it is inserted all the way into the leg
STEP 3: Attatch other Leg (F) by aligning the holes
on the legs with the pegs from the Slats (I). Ensure
the leg is pressed down onto the pegs completely.
STEP 4: Attach Seat Back (H) by lining up the
cutouts on the underside of the Seat Back (H) with
the holes on the top of each Leg (F). Secure with
both Small Bolts (A)
STEP 5: Place Bracket (D) into
one of the cutouts in Slat (I)
with open edge facing inwards
STEP 6: Place Large Bolt (B) through Bracket (D) and tighten using
the Assembly Key (E). Repeat STEP 5 & 6 for each one of the 4 total
cutouts on the Slats (I) to secure the assembly.
PUSH
DOWN
STEP 2: Insert the Large Slat (I) into straight beam
of the same Leg (F) as STEP 1 with holes facing
inwards and once again making sure it is all the
way inserted.
PUSH
DOWN
I
I
I I I
I
F
F
F
D
B
E
D
H
F A
D