User Manual

Figure 13: Outside Vertical Installation.

Installation

outSide vertical inStallationS:

To accomplish an outside vertical pipe installation, follow the “Horizontal ExHaust tHrougH Wall installations”

section and then finish it by performing the following.

1. Install a tee with clean out on the outside of the house.

2. Install PL vent upward from the tee. Make sure that you install support brackets to keep the vent

straight and secure. All joints in the exhaust venting system must be fastened with at least three (3)

screws.

3. Install ceiling thimble and secure the flashing as you go through the roof.

4. Ensure that the rain cap is a minimum of 24” (61 cm) above the roof.

NOTE - This venting configuration is only for use with the Built-In installation.

Rain cap

Flashing

24"

(61 cm)

Tee with

cleanout

3" (7.5 cm)

Clearance

Support

bracket

Type "L"

vent

Hampton GCI60 Cast Pellet Insert Technical Manual