Owner`s manual

INSTALLING THE FAN
ELECTRICAL CONNECTIONS
WARNING: To avoid damaging the blade arms and blades,
do not install them onto fan until fan is fastened to ceiling.
1. Lift ball/downrod/fan into hanging bracket opening.
NOTE: The tab opposite hanging bracket opening should fit
in slot on ball.
WARNING: To avoid possible electrical shock be sure electricity is turned off at the main fuse or breaker box before
wiring.
1. Connect the fan supply (black) wire to the black household supply wire as shown in Figure 4.
2. Connect the neutral fan (white) wire to the white neutral household wire. (Fig. 4)
3. After all splices are made, check to make sure there are no loose strands. As an additional precaution we suggest to
secure the plastic wire connectors to the wires with electrical tape.
6
Slot
Tab
Outlet Box
Black ("AC IN L")
White ("AC IN N")
White (Neutral)
Black (Motor)
Fig. 3
Fig. 4
Green or bare
copper (ground)
Ground (green)
(Connect to ground wire on
hanger bracket if no house
ground wire exists.)