Instruction Manual

Regency Bellavista™ B41XTCE Gas Fireplace

INSTALLATION

Caution Requirements

The top, back and sides of the ﬁ replace are deﬁ ned by

standoffs. The metal ends of the standoff may NOT be

recessed into combustible construction.

WARNING

Fire hazard is an extreme risk

if these clearances (air space) to combustible materials are not

adhered to. It is of greatest importance that this ﬁ replace and vent

system be installed only in accordance with these instructions.

CLEARANCES

The clearances listed below are Minimum distances unless otherwise stated:

A major cause of chimney related ﬁ res is failure to maintain required clearances (air space) to combustible materials. It is of the greatest

importance that this ﬁ replace and vent system be installed only in accordance with these instructions.

B41XTCE Clearance Requirements

Horizontal Top 3" (76mm)

Horizontal Side 2 " (51mm)

Horizontal Bottom 2" (51mm)

Vertical Vent 2" (51mm)

NOTE: A 16" deep non-combustible hearth pad is

recommended for hardwood ﬂ ooring and carpet.

Clearance: Dimension Measured From:

A: Mantel Height (min.) 17-9/16" (446mm) Top of Fireplace Opening

B: Sidewall 9" (229mm) Side of Fireplace Opening

C: Ceiling 36-5/8" (930mm) Top of Fireplace Opening

D: Mantel Depth (max.) 12" (304mm) 25-13/16" (651mm)

from Top of Fireplace Opening

E: Alcove Width 60" (1524mm) Wall to Wall (Minimum)

F: Alcove Depth 36" (914mm) Front to Back Wall (Maximum)

Notes: 0" No Hearth Required

Minimum Vent Clearances

to Combustibles

Alcove

Close to Ceiling