Owner`s manual

INSTALLING THE FAN

1. Carefully support fan body (motor) in its styrofoam packing with the mounting collar (where the wires come out)

facing upward.

2. Loosen the two set screws and remove the downrod pin and cotter pin from the top coupling of the motor assembly.

3. Remove ball from the downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin;

remove ball.

4. Feed the wires from top of fan through end of the downrod of choice and set end of downrod into mounting collar so

the hole in the downrod lines up with the hole in the side of the mounting collar.

5. Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in end of

downrod pin to hold downrod in place.

6. Tighten jam screws against downrod using a large flat blade screwdriver to ensure a tight fit against downrod. Tighten

nuts against mounting collar.

NOTE:

Fan has 6 feet of hook-up wire in case

you are using a long extension downrod. Wires

can be cut so only 8 inches or so extend beyond

the top of the downrod to make the electrical

connections easier and safer.

7. Feed wires through collar cover and slide

collar cover down the downrod to top of fan.

8. Feed wires through canopy screw cover plate

and canopy, then slide both over downrod to

lay on top of collar cover. It will be attached

to ceiling later.

9. Feed wires through ball and slide ball over

downrod, past hole in the top end of the

downrod. Insert ball pin (removed in step 3),

slide ball up, and tighten set screw to secure

ball in place.

Hook-up (3)

Wires

Ground

Wire

Ball

Canopy

Canopy Screw

Cover Plate

Downrod

Mounting Collar

Downrod Pin

Top of

Fan Body

Collar Cover

Security

Screws

Cotter