Owner`s manual

INSTALLING THE FAN
6
1. Carefully support fan body (motor) in its styrofoam packing with the mounting collar (where the wires come out)
facing upward.
2. Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin;
remove ball.
3. Feed the wires from top of fan through end of downrod you have chosen and set end of downrod into mounting
collar so the hole in the downrod lines up with the hole in the side of the mounting collar.
4. Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in end of
downrod pin to hold downrod in place.
5. Tighten jam screws against downrod using a large flat blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
NOTE: Fan has 6 feet of hook-up wire in case
you are using a long extension downrod.
Wir
es can be cut so only 8 inches or so extend
beyond the top of the downrod to make the
electrical connections easier and safer.
6. Feed wires thr
ough collar cover and slide
collar cover down the downrod to top of
fan. Tighten collar cover set screw.
7.
Feed wires thr
ough canopy and slide
canopy over downrod to lay on top of
collar cover. It will be attached to ceiling
later.
8.
Feed wir
es thr
ough ball and slide ball
over downrod, past hole in the top end
of the downrod. Insert ball pin
(removed in step 2), slide ball up, and
tighten set screw to secure ball in place.
Ground
Wire
Hook-up
Wires
Ball
Collar Cover
Jam Screws with
Locking Nut
Mounting Collar
Downrod
Pin
Cotter
Pin
Canopy
Downrod
(2)
Top of
Fan Body
ATTACH DOWNROD: