Owner`s manual

10
Detachable
Switch Housing Hub
(attached to fan motor)
Side Screw
Connector
Switch Housing
Connector
Pull Chain
Reverse Switch
Side Screw Hole
Pull Chain
INSTALLATION OF REMOVABLE SWITCH HOUSING
NOTE: Be sure the power is off before installing.
1. Snap switch housing hub mated connectors to switch housing connectors.
2. Attach the switch housing to the switch housing hub. Align the side screws with keyhole slots on edge of switch
housing and tighten the side screws.
5. Attach pull chain fobs to ends of the switch’s pull chains – one for fan speed and one for uplight on/off.
6. Install candelabra base (E12) bulbs into sockets on top of fan housing for uplight. DO NOT EXCEED THE
RECOMMENDED WATTAGE FOR EACH BULB!
7. Turn the power on. Your Regency Ceiling Fan is now ready to enjoy!
Connector example only