Owner`s manual

BLADE ATTACHMENT

BLADE TO BLADE ARM ATTACHMENT

Blade

Blade Arm

1. Place washer on screw. Insert this assembly through

the blade and start the screw into the blade arm.

Repeat this procedure without tightening the screw

until all 3 screws have been started into the blade

arm (Fig. 2).

2. Tighten each screw, starting with center screw.

BLADE ARM TO MOTOR ASSEMBLY

1. With the motor assembly hung in place, the blade arms with blades attached can be installed. Remove the screws

and L-wrench from the scr

ew packet supplied.

2. One by one, place the blade arms with blade attached to the mounting holes on the rotor. Align the holes in the arms

with matching holes on the r

otor and install the screws from inside of the r

otor using the supplied L-wrench.

Note: Blade arm should be below the blade and not on top of the blade.

3. Once both of the screws are installed in each blade ar

m, secure the screw tight with the supplied L-wrench.

Blade

Blade Arm