Owner`s manual

ASSEMBLY INSTRUCTIONS: DOWNROD AND CANOPY
1. Carefully support fan housing (motor) in its styrofoam packing with the mounting collar (where the wires come
out) facing upward.
2. Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin;
remove ball.
3. Attach glass w/screws to the top of the motor housing.
4. Feed the wires from top of fan through the end of the downrod, and set end of downrod into mounting collar so
the hole in the downrod lines up with the hole in the side of the mounting collar.
5. Insert downrod pin through holes in mounting collar and downrod and insert cotter pin to secure downrod.
6. Tighten security screw against downrod
using a large flat blade screwdriver to
ensure a tight fit against downr
od. T
ighten
lock nut to mounting collar.
NOTE: Fan has 6 feet of hook-up wir
e in case you
ar
e using a long extension downrod. Wires can be
cut so only 8 inches or so extend beyond the top
of the downrod to make the electrical connections
easier and safer.
7. Feed wires through canopy and slide
canopy over downrod to lay on top of
collar cover. Canopy will be attached to
ceiling later.
8. Feed wires through ball and slide ball over
downrod, past hole in the top end of downrod.
Insert ball pin (removed in Step 2), slide ball
up and tighten set scr
ew to secur
e ball in
place.
9. Install 4 candelabra base bulbs (E12, 25w
max) in top sockets.
Ground
Wire
Hook-up Wires (3)
Ball
Security Screw and Lock Nut
Mounting Collar
Collar Cover
Downrod Pin
Fan
Housing
Canopy
Downrod
25W Candelabra
Base Bulbs
Cotter Pin
5