Owner`s manual

GENERAL INSTALLATION & OPERATION INSTRUCTIONS
IMPORTANT SAFEGUARDS:
1. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly
before beginning.
2. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring. All electrical
connections must be made in accordance with local codes, ordinances and/or the National Electric Code. If you are
unfamiliar with the methods of installing electrical wiring and products, secure the services of a qualified and
licensed electrician as well as someone who can check the strength of the supportive ceiling members and make
the proper installation(s) and connections.
3. Make sure that your installation site will not allow rotating fan blades to come in contact with any object. Blades
should be at least 7 feet from floor when fan is operating.
4. The fan should be mounted on a ceiling outlet box, an approved box UL listed as
“suitable for fan support” is
required. The box and its supporting members must be able to support the moving weight of the fan (at least
35lbs.). The box must not be able to twist or work loose. Installation on a concrete ceiling should be performed
by qualified personnel.
5. Blades should be attached after
motor housing is hung and in place. Fan motor housing should be kept in the
car
ton until ready to be installed to protect its finish. If you ar
e installing more than one ceiling fan, make sure
that you do not mix fan blade sets, as each blade is part of a weighted set.
6. After making electrical connections, spliced conductors should be turned upward and pushed carefully up into
outlet box. The wires should be spread apart with the common conductor and the grounding conductor on one
side of the outlet box, and the “HOT” wir
es on the other side.
7. Electrical diagrams are for reference only.
8.
After fan is completely installed, check to make sur
e that all connections ar
e secur
e to prevent fan from falling
and/or causing damage or injury.
9.
The fan can be made to work immediately after installation - the bearings ar
e adequately char
ged with gr
ease so
that, under nor
mal conditions, further lubrication should not be necessary for the life of the fan.
10. The fan should be turned off and allowed to stop rotating before reversing fan direction.
1