Owner`s manual

1. Place washer on screw. Insert this

assembly through the blade and start

the screw into the blade arm. Repeat

this procedure without tightening the

screw until all 3 screws have been start-

ed into the blade arm (Fig. 1).

2. Tighten each screw, starting with center

screw.

3. Fasten blade assembly to motor with

provided screws and metal lockwashers

(Fig. 2). repeat procedure for remaining

blades. Make sur

e screws are TIGHT!

Loose motor screws can contribute to unnecessary hum and wobble during operation.

NOTE: Cordless power scr

ewdrivers ar

e NOT recommended, as they tend to strip the heads of the screws and

usually will not fully compress the spring washers on the motor scr

ews. Use a lar

ge flat blade screwdriver for

final tightening to fully compress the spring washers. This will help ensure proper alignment of the blades and

noise-free, wobble-free running.

Blade assembly

Blade to motor screw

and metal lock washer

BLADE & BLADE ARM ATTACHMENT

Screw

asher

lade

lade Arm

Fig. 1