Specifications

Use of the Tuner

Manual Tune

Select the required waveband, either AM/FM, then press the manual

button. The button will then light up, if you then press the UP or

DOWN buttons you will step through the frequency band selected.

The MHz or kHz logo lighting indicates a tuned station. Stereo logo

will also light if the station is broadcasting in 'stereo'.

Auto Tune

Select the required waveband, either AM/FM, then press the auto

button. The button will then light up, if you then press the UP or

DOWN buttons you will search through the frequency band selected

until the radio fines a strong signal. You can stop the search by

pressing the button again. The radio will tune to stations that

broadcast in stereo and mono. If the radio will not tune in to your

desired station, you will need to use the manual-tuning mode.

Programming the Pre-sets

Use either Auto or Manual to tune to the desired frequency / station.

Press the program button and the memory logo will light on the

display, showing that you are in the programming mode. You must

then choose a pre-set number to store the frequency / station in, this

is done using the UP or DOWN buttons. Once you have chosen the

pre-set number, press the program button once more to store the

frequency / station into that pre-set.

Radio Mk3 Manual v3-3.qxd 14/06/2004 09:50 Page 8