Specifications

Front Panel Switches

1) Pre-set - Selects Pre-set station mode. The switch will light to

indicate the Pre-set mode is activated.

2) Auto - Selects Auto tune mode, this will enable automatic scan

through the band searching for strong stations available in your

area. The switch will light to indicate the Auto mode is activated.

3) Manual - Selects Manual tune mode, this will step through the

FM and AM bands in steps of 25KHz & 9/10KHz respectively. The

switch will light to indicate the manual mode is activated.

4) Down - Move, scan or step down in Pre-set, Auto or Manual

tuning modes respectively.

5) UP - Move, scan or step up in Pre-set, Auto or Manual tuning

modes respectively.

6) Display - see front panel display on Page 6.

7) Power on/off - This turns the tuner on or off. When the tuner is

off, the microprocessor will stay active. If in the event of a processor

hang-up or crash, the processor can be reset. This is done by

turning the tuner off at the front panel, removing the mains plug from

the back panel and then plugging it in again after a few seconds.

This will not affect any stored data in the memory.

Radio Mk3 Manual v3-3.qxd 14/06/2004 09:49 Page 5