Specifications

Page 3-22 RM2151 - USING THE RADIOTELEX SYSTEM
By high-lightning the file you want to view and press Enter, the contents of the file can be examined. If the file and
the ‘Print’ command from the command line both are high-lighted and you press Enter the contents of the file will
be printed.
The files shown in the Directory will have the contents of the received message and are set up when you are receiving
an ARQ or a FEC call. The files named FEC will be overwritten when they are older than 25 hours. The files named
ARQ will be overwritten when the floppy disk is full of ARQ files.
A file which has the contents of all the on-line traffic, can be activated as ‘Save to printer’ or ‘Save to file’. Activate
this by entering the menus:
F3 The radiotelex menu is selected.
DIRECTCALL The directcall menu is selected.
COMMANDS The directcall Commands menu is selected.
Editor 11 01
DirectCall LOCK CONNECT SEND REPEAT
Call Commands Over End Frequency
Who-are-you
> This-is
Call i Send time
Send bell
Waitin
Checki On-line shell...
> Send file...
Clear Send text
Stop sending file or text
Standb
> Save to printer
Save to file. Filename:
290292b
Status: Scanning ARQ Rx: 4204.0 Tx: 4204.0
Save to printer Save to printer, (connected to the Message terminal or PC) save any on-line traffic. To
activate save to printer high-light “save to printer” and press Enter, the symbol >> appears with
the command.
Save to file Save to file (any on-line traffic) on the disk of the Message Terminal or PC. The file shall be
given a name when opened and the file shall be closed before it is possible to view the contents.
The file is open when save to file is provided with the symbol >>. The file can be closed by
high-lightning the ‘Save to file’ command and then activate the Enter key, the symbol >>
disappears and the file can be viewed.
Remember to close the file before the contents is viewed.
It is wise to open a new file directlly after closing the old.