User Manual

10
SPECIFICATIONS
AMPLIFIER OUTPUT
Power Amplier Output (at rated 230/115V supply voltage) 105W per channel into 8Ω
127W per channel into 6Ω
162W per channel into 4Ω
Note: Continued high level use into loads of or less may cause
the case to exceed 40°C above ambient temperature and activate
the thermal shut down.
Headphone Output No Load 11.5V
300Ω 8.1V
54Ω 3.6V
32Ω 2.4V
Source Impedance 109Ω
DISTORTION
THD+Noise (at 1dB below clip into measurement bandwidth 22Hz to 22kHz)
Direct Input (Power Amplier) Typically 0.005% at 1kHz
Line Inputs Typically 0.007% at 1kHz
Preamplier Output Typically 0.004% at 1kHz
FREQUENCY RESPONSE
Bandwidth (at 80W into 8Ω)
Direct Input 12Hz (0.5dB) to 95kHz (-3dB)
Line Inputs 10Hz (-1dB) to 85kHz (-3dB)
Phono Input 15Hz (-3dB) to 85kHz (-3dB)
RIAA Accuracy Better than ±0.5dB 100Hz to 20kHz
SENSITIVITY
Input Sensitivity (for 105W into 8Ω)
Line Inputs 2-5 and Record 196mV load 10k
Phono 2mV load 47k in parallel with 220pF
Direct Input 760mV load 50k
Power Amplier Gain 31.6dB
Output Sensitivity (at rated inputs)
Record Output 196mV
Pre-amplier output 760mV
DIGITAL INPUTS
Input D1 S/PDIF Isolated 0.5V 75Ω Co-axial
Input D2 S/PDIF Optical Toslink
Supported Sampling Rates 32, 44.1, 48, 88.2, 96, 176.4, 192kHz
Supported Bit Depths 16 to 24 bit
THD+Noise (DAC Output from Tape Out) Typically 0.004% at 1kHz
DIMENSIONS AND WEIGHT
Dimensions (WxHxD) 432 x 82 x 340mm (17 x 3.25 x 13.4in)
Net Weight 12.5kg (27.5lbs)
Packed Weight 14kg (30.9lbs)
POWER
Power Supply AC supply 230V / 220V / 115V / 100V nominal ±10%
Power Consumption 375W at 1dB below clip into
Fuse Ratings T4 AL 250V - 230V 50Hz / 220V 60Hz
T8 AL 250V - 115V 60Hz / 100V 50/60Hz
Remote Batteries AAA (1.5V) x 2