Submittal Sheet

Converting from Foaming Nozzle mode to Jet Nozzle mode
1. Press blue Pressure Relief Valve ⑧ to relieve pressure inside Canister ⑭
2. Separate Foamer Sprayer Housing ⑦ from Canister ⑭
3. Remove Foam Liquid Pickup Tube (Black) ⑬ by pulling the fitting as indicated by the arrow in Figure 1
4. Store Foam Liquid Pickup Tube (Black) ⑬ in a safe place for reuse
Figure 1
Figure 2
5. Push Spray Liquid Pickup Tube (White) ⑮ into hole in Foamer Sprayer Housing ⑦
6. Unscrew Foam Nozzle Complete ④ from Foam Sprayer Housing ⑦ and replace with Spray Nozzle Complete ⑲
7. Store Foam Nozzle Complete ④ in a safe place for reuse
8. Reinstall Foam Sprayer Housing ⑦ onto Canister ⑭ and tighten
9. Pressurise sprayer by pumping Hand Pump ⑥ until Pressure Relief Valve ⑧ begins to release
10. Check for leaks and retighten Foam Sprayer Housing ⑦ on Canister ⑭ if necessary
Converting from Jet Nozzle mode to Foaming Nozzle mode
Reverse the procedure described in Converting from Foaming Nozzle mode to Jet Nozzle mode to convert the unit back
to a Foam Sprayer.
Manufactured for:
Refrigeration Technologies
1111 N. Armando St, Anaheim CA 92806 USA
[phone] | www.refrigtech.com
Distributed in Asia Pacific by:
SuperCool Asia Pacific
14 Motorway Circuit, Ormeau QLD 4208 Australia
[phone] | www.supercool.com.au
Rev.4-03082020