SDS

General ventilation.
Wear eye/face protection.
Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. Check leak-
tightness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off and air
them well. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves men-
tioned above together with the supplier of these gloves.
Take recovery periods for skin regeneration. Preventive skin protection (barrier creams/ointments) is recommended.
Wash hands thoroughly after handling.
In case of inadequate ventilation wear respiratory protection.
Use appropriate container to avoid environmental contamination. Keep away from drains, surface and ground water.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
8.2 Exposure controls
Appropriate engineering controls
Individual protection measures (personal protective equipment)
Eye/face protection
Skin protection
- Hand protection
- Other protection measures
Respiratory protection
Environmental exposure controls
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Physical state liquid
Color Conforms to Standard
Odor Conforms to standard
- PH (value) not determined not determined
Melting point/freezing point not determined
Initial boiling point and boiling range not determined
Flash point 74 °C
Evaporation rate not determined
Flammability (solid, gas) not relevant (fluid) not determined
Explosive limits not determined
Vapor pressure 0.25 hPa
Density not determined
Vapor density this information is not available
Relative density information on this property is not available
Solubility(ies) not determined
Partition coefficient not determined
Auto-ignition temperature not determined
Safety Data Sheet
acc. to 29 CFR 1910.1200 App D
Version number: 1.0 Date of compilation: 2015-12-23
United States: en
HS 334 SDS-04:
Page: 6 / 10