User's Manual

FCC 

Federal Communications Commission (FCC) Statement 



This equipment has been tested and found to comply with the limits for a class B digital device, 

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates and uses and 

can radiate radio frequency energy and if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of 

the following measures: 



1. Reorient or relocate the receiving antenna. 

2. Increase the separation between the equipment and receiver. 

3. Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

4. Consult the dealer or an experienced radio/tv technician for help. 

FCC RF Radiation exposure statement: 

1. This transmitter must not be co-located or operating in conjunction with any other antenna 

or transmitter 

2. This equipment complies with RF radiation exposure limits set forth for an uncontrolled 

environment. This equipment should be installed and operated with a minimum distance of 20 cm 

between the radiator and your body. 

This device complies with part 15 of the FCC rules. Operation is 

subject to the following two conditions: 

1. This device may not cause harmful interference and 

2. This device must accept any interference received, including interference that may cause 

undesired operation. 



Working temperature: 32F to 104F (0C to 40C) 

Working Voltage: 110V to 240V 

USB port is only used for peripherals or ADB access. 



Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.