Manual

- 14 -
Setting the time
1. To set the time, proceed as follows.
2. Press and hold button [12] in standby mode.
3. Press the or buttons [16] to set the time display.
 12H = 12 hour display.
 24H = 24 hours display.
4. Press the [12] button to confirm and enter the hour selection. The hour display
flashes.
5. Press the or buttons [16] to set the hours.
6. Press the [12] button to confirm and enter the minutes selection. The minutes
display flashes.
7. Press the or buttons [16] to set the minutes.
8. Press the [12] button to confirm and complete the time setting.
Note:
 The time can only be set in standby mode.
 Make sure that two AA batteries are inserted in the Back Up battery
compartment so that the time remains stored in the event of a power failure
or disconnection from the mains when the unit is switched on again.
Setting the alarm clock
1. To set the alarm clock, proceed as follows.
2. Press and hold the remote control button in standby mode.
3. The hour display flashes in the display.
4. Press the following buttons / to set the hours.
5. Press the remote control button to confirm the hours and switch to the
minute selection. The minute display flashes.