User manual

- 25 -
Appendix A: External Device (USB 2.0/Firewire 1394) Setup Guide (Optional)
* This only applies if you have USB 2.0 or Firewire conn ections installed
If there s a switch next to the USB/Firewire Port:
1. Power off your system
2. Set the USB2.0 /Firewire switch to ON position at the back of your system (away from
the LED lights)
3. Using the standard USB 2.0 /Firewire cable to connect your comp uter to your system .
4. Power on your system .
5. Y our computer should recognize a number of external devices depend ing on the system
you purchased.
If there is NOT a switch next to the USB/Firewire Port:
1. Using the standard USB 2.0/Firewire cable to connect your computer and your system.
2. Power on your system .
3. Go in to menu 5 Utilities
4. Go in to submenu 10 USB Connection or External Connection
5. Press up or down button to change the setting to ON .
6. Press ENT /Enter button to submit your selection.
7. The system wi ll either restart by itself or prompts you restart it manually by power ing the
system off and back on.
8. Your computer should recognize a number of external devices depend ing on the system
you purchased.
Above instructions are for you to turn on the USB/F irewire port. However, if you
wish to turn it off, please perform the same instruction s except you either set the
USB 2.0/Firewire switch to OFF or change the USB Connection/Firewire
Connection setting to OFF .
Every PC related product ha s compatibil ity issue s . Even though the USB 2.0/
Firewire connection(s) have been thoroughly tested before the unit was shipped
out of the factory , there s still a slight chance that your PC/Mac computer is not
compatible with the units USB 2.0/ Firewire connection. I f that happens, please
contact your PC/Mac manufacture for possible configuration changes to make it
work or try it on another PC/Mac computer .