User manual
- 10 -
Select the Duplication Speed
This process will allow you to adjust the duplication speed subject to your needs.
By default, the duplication spe
ed will be set to the optimal speed
for each format and setting
.
However, under some circumstances, you m
ay
want to
reduce
the duplication speed. Those
circumstances
typically
are as follows:
Poor Blank Media Quality
.
When your blank
media quality is not good, lowering down the
duplication speed is necessary to make good copies.
Poor Master Disc Quality
.
If your master disc condition is not good, lowering down the
duplication speed will
greatly
reduce the failure rates.
Duplication Quality.
Overall, the lo
wer the speed, the higher the quality of your duplicates.
If you have time, it is a good choice to lower down the speed to produce the best quality
duplicates.
When you turn on your
system
, after it has booted up, you should see the following signifying
y
our
system
is ready.
Step 1:
Use the up or down arrow button to navigate to the
Setup
menu
press
ENT /Enter.
navigate to select burn speed
Step 2:
Press
the
ENT /Enter button to enter the
Select
Burn Speed
menu and you shall
see a screen similar to below:
Step 3:
Select
the
Correct Speed Type
There are
different types
of recording speed
based on the disc format and source
:
CD to CD:
Copy
ing
to CD
-R
/RW
m
edia
from
a
p
re
-
loaded
a
CD
m
aster
d
isc
in
the
Reader/Writer
.
DVD to DVD:
Copy
ing
to DVD±R
m
edia from
a
DVD
m
aste
r
disc i
n the
Reader/Writer.
DVD
-
DL to DVD
-
DL:
Copy
ing
to
Double/Dual Layer Recordable
DVD
m
edia
from
a
Double/Dual Layer DVD master disc in the Reader/Writer.
BD to BD:
Copying to BD
-
R/RE m
edia from
Blu
-
ray
master disc in the
Reader/Writer
.
(only available
if Blu
-
ray drives are installed)
Depending on
the
type of duplication
job
(s) and your
system
restrictions, you need to
select the correct
speed type in order for this setting to
take effect. To select
various
speed types, you
need to press
the
up
or
down
button to adjust and press
the
DISCMAKERS
X
.
xx
4
.
Setup
Select Burn Speed
CD to CD
DISCMAKERS X
.
xx
1.Copy
DISCMAKERS X.xx
6.Select Burn Speed