Installation Guide

Recommended Products:

Reflective/Bubble/Bubble/Reflective - Roll: BP24025 (24”x 25’)

Staple Tab, Reflective/Bubble/Bubble/Reflective - Roll: ST16025 (16”x 25’), ST24025 (24”x 25’)

Installation Instructions:

• Inspect the installation area and make any needed repairs before installing the Reflectix

Reflective/

Bubble product.

• Check the basement ceiling to determine whether the joists are 16” or 24” on-center.

• Begin at one end of the house and staple the product to the top of the band board or the subfloor (also

terminating this course in this fashion).

• Insert the Reflectix

half way up into the joist cavity and staple (at approximately 3” to 4” intervals) the

edge of the product to the side of the joist.

• The goal is to split the joist cavity into two approximately equal enclosed air spaces.

• Finish the ceiling with the specified panel or sheetrock.

1. Reflectix

Insulation

2. Sheet Rock

3. Band Board

4. Sub-Floor

5. Floor Joist

Tools Required:

Safety Glasses

Staple Gun

Tape Measure

Utility Knife/Scissors

DIY Basement Ceiling| (R-16)

Reflectix

Installation Instructions

1 5