Installation Guide

Recommended Products:

Reflective/Bubble/Bubble/Reflective - Roll: BP24025 (24”x 25’), BP48025 (48”x 25’)

Staple Tab, Reflective/Bubble/Bubble/Reflective - Roll: ST16025 (16”x 25’), ST24025 (24”x 25’)

Installation Instructions:

• Inspect the crawl space and make any needed repairs before installing Reflectix

Reflective/Bubble

product.

• Check the crawl space to determine whether the floor joists are 16” or 24” on-center.

• Determine if there are water pipes and heating ducts which hang below the floor joists. They will

need to be insulated. Reflectix

Pipe Wrap and Duct Insulations are designed specifically for this use.

There is no need to wrap water pipes or duct work that fall between floor joists. Reflectix

will provide

adequate insulating without extra wrapping.

• Start at the end of the house and face staple to the bottom of the floor joists. Seal seams with Reflectix

Foil Tape to create a vapor barrier. At the end, staple up to the sub-floor or band board.

• Note: Existing mass insulation in the joist cavities must be dry prior to installing the Reflectix

product.

1. Reflectix

Insulation

2. Concrete Block

3. Band Board

4. Sub-Floor

5. Floor Joist

Tools Required:

Safety Glasses

Staple Gun

Tape Measure

Utility Knife/Scissors

DIY Crawl Space| (R-16)

Reflectix

Installation Instructions