Installation Instructions

Recommended Products:

Reflective/Bubble/Bubble/White - Roll: RDBW48100 (48”x 100’)

Open Interior with 1”x 2” Furring

R-7.5* Heat Flow Down

R-3.6* Heat Flow Up

Installation Instructions:

• The Reflectix

Insulation is installed with the “white side” towards the interior of the building.

• Pre-installation inspection - Check the roof area for clutter, water sprinklers, conduit and lights.

Sprinkler systems are especially important. All water pipes must be below the Reflectix

Reflective/Bubble/Bubble/White Insulation to prevent the possibility of freezing in the winter. In

many instances the Reflectix

product must be installed up near the roof deck.

• Install 1”x 2” furring strips on the bottom of and perpendicular to the Z purlins on 22” centers.

Utilize 1 1/4” self-tapping sheet metal screws to secure the furring strips to the Z purlins.

• Butt the furring strips together and tape. Staple tape for reinforcement.

• Attach the product using 5/16” staples at approximately 4” intervals.

• Staple the edges of the Reflectix

Reflective/Bubble/Bubble/White product to the furring strips with a

3/4” overlap at the seams.

1. Reflectix

Insulation

2. Exterior Roof Panel

3. Purlin

4. 1”x 2” (Nominal)

Furring Strip

5. Red Metal (Structural

Frame)

Tools Required:

Safety Glasses

Tape Measure

Utility Knife

Screw Gun

Staple Gun

Metal Building / Roof / Retrofit

Reflectix Installation Instructions