Installation Instructions

Recommended Products:

Reflective/Bubble/Bubble/White - Roll: RDBW48100 (48”x 100’)

Below the Purlins

Open Interior • R-6.4* Heat Flow Down | R-3.7* Heat Flow Up

Above the Purlins

Open Interior • R-3.8* Heat Flow Down | R-3.5* Heat Flow Up

Installation Instructions: (There are 2 options)

1. Metal Roof with Product below Purlin

• The Reflectix

Insulation is installed with the “white side” towards the interior of the building.

• After the trusses are set, run two purlins to make sure the trusses stay true.

• Attach the Reflectix

Reflective/Bubble/Bubble/White product to the first truss with at least 5/16”

staples. Temporarily nail a 2”x 4” block over the end of the product to prevent it from pulling away.

• Roll out the product across the top of the trusses, pull tight and staple.

• Run subsequent courses of the product with a 3/4” overlap at the seams.

• Tape the seams with a Reflectix

Foil Tape (goal is an air-tight, snug seam seal).

1. Reflectix

Insulation

2. Exterior Roof Panel

3. Purlin

4. Truss

Tools Required:

Safety Glasses

Tape Measure

Utility Knife

Staple Gun

Post and Frame Building / Roof / New

Reflectix Installation Instructions