Installation Instructions

Recommended Products:

Reflective/Bubble/Bubble/White - Roll: RDBW48100 (48”x 100’)

Inside the Girts

Open Interior • 4.2* Heat Flow Horizontal

Outside the Girts

Open Interior • R-3.7* Heat Flow Horizontal

Installation Instructions: (There are 2 options)

1. Product Inside the Girts

• The Reflectix

Insulation is installed with the “white side” towards the interior of the building.

• Attach the product using 5/16” staples at approximately 4” intervals.

• Staple the Reflectix

Reflective/Bubble/Bubble/White product to the outside of the top girt.

• Staple the product to the inside of the remaining girts.

• Tape the seams with a Reflectix

Foil Tape (goal is an air-tight, snug seam seal).

1. Reflectix

Insulation

2. Exterior Wall Panel

3. Girt

4. Post

Tools Required:

Safety Glasses

Tape Measure

Utility Knife

Staple Gun

Post Frame Building / Wall / New

Reflectix Installation Instructions