Installation Guide

Recommended Products:

Reflective/Bubble/Bubble/White - Roll: RDBW48100 (48”x 100’)

Bottom of the Trusses

Open Interior

R-6.6* Heat Flow Down | R-3.0* Heat Flow Up

Installation Instructions:

• The Reflectix

Insulation is installed with the “white side” towards the interior of the building.

• Pre-installation inspection - Check the roof area for clutter, water sprinklers, conduit and lights.

Sprinkler systems are especially important. All water pipes must be below the Reflectix

Reflective/Bubble/Bubble/White Insulation to prevent the possibility of freezing in the winter.

• Nail 1”x 2” furring strips on the bottom of and perpendicular to the trusses on 22” centers. (Note:

When truss spacing is 24” it is recommended to install the Reflectix

Reflective/Bubble/Bubble/White

48” product directly to the bottom cord of the truss.)

• Butt the furring strips together and tape. Staple tape for reinforcement.

• Staple the edges of the Reflectix

to the furring strip with 5/16” staples at approximately 4” intervals.

Run subsequent courses of the product with a 3/4” overlap at the seams.

1. Reflectix

Insulation

2. Exterior Roof Panel

3. Purlin

4. Truss

5. 1”x 2” (Nominal)

Furring Strip

Tools Required:

Safety Glasses

Tape Measure

Utility Knife

Staple Gun

PF Bldg / Roof / Retro / Bottom of Trusses

Reflectix Installation Instructions