Installation Instructions

• Thermal Performance A
STM C518
• Fungus Resistance Mil-Std 810B M
ethod 508
• Pliability Test
• Water Vapor Transmission ASTM E96
• Tensile Strength
Testing and Certification:
Product Standards:
Resistance to fungi or bacteria: Reflectix
®
does not promote
the growth of fungi or bacteria.
All tests on Reflectix
®
Insulation are performed at either nationally approved independent laboratories or at leading universities.
Tests are performed to current American Society of Testing and Materials (ASTM) Standards when a standard exists. For a copy of any
of the actual test reports, call 1 [phone].
Radiant Heating in a Concrete Floor
1) Unroll Reflectix
®
Concrete Slab Insulation over the sand or
gravel, (white poly side up.)
2) Butt the seams.
3) Seal the seams with 3” wide poly tape. All tape should be
applied using a flat edge taping tool to assure good
adhesion.
4) Install radiant heating and reinforcing rod, and then pour
the concrete as usual.
Builder’s Note: Adding 1” of sand over the Reflectix
®
Concrete
Slab Insulation will facilitate water drainage and shorten the
actual curing time.
Under a Concrete Slab
1) Unroll Reflectix
®
Concrete Slab Insulation over the sand or
gravel, (white poly side up.)
2) Butt the seams.
3) Seal the seams with 3” wide poly tape. All tape should be
applied using a flat edge taping tool to assure good
adhesion.
4) Install reinforcing rod and then pour the concrete as
usual.
Builder’s Note: Adding 1” of sand over the Reflectix
®
Concrete
Slab Insulation will facilitate water drainage and shorten the
actual curing time.
Saving Energy, Radiating Quality.
Reflectix, Inc. • P.O. Box 108 • Markleville, IN • 46056
Phone: [phone] or [phone]
Fax: [phone]
Web: www.reflectixinc.com
E-mail: [e-mail]
F43 Rev 1115