Installation Guide

N24 LowesCan Revised 0512

Temperature Range: -60 degrees to +180

degrees F

Nominal Thickness: 5/16 inch (.312)

Weight: 1.25 oz./sq. ft.

Linear Shrinkage: None

ater Vapor Transmission (ASTM E 96): 0.02 Perms

Puncture Resistance: 60 lb./in.

Mold and Mildew: No Growth

Tensile Strength: 3.7 N/mm

Pliability: No Cracking

Physical Properties - Compression 6%

T e c h n i c a l D a t a :

MANUFACTURER’S SUGGESTED INSTALLATION INSTRUCTIONS

Note: Installation instructions and illustrated drawings are recommendations only,

while proper local construction methods are the responsibility of the installer.

RADIANT FLOOR OVER AN EXISTING FLOOR

• Unroll the Reflectix

Concrete Slab Insulation over the existing floor prior to pouring the concrete (white poly side facing up). Cut product flush with

the walls.

• Butt the seams of the product and seal with 3” wide poly tape. Note: Utilize a flat edge taping tool to assure good adhesion on all tape.

• Install Radiant Floor System per manufacturer’s specifications.

RADIANT FLOOR IN A CONCRETE SLAB

• Unroll the Reflectix

Concrete Slab Insulation product over the base material prior to pouring the concrete (white poly side facing up).

• Butt the seams of the product and seal with 3” wide poly tape. Note: Utilize a flat edge taping tool to assure good adhesion on all tape.

• Install Radiant Floor System per manufacturer’s specifications.

CONCRETE SLAB (SNOW MELT)

• Unroll the Reflectix

Concrete Slab Insulation product over the base material prior to pouring the concrete (white poly side facing up).

• Butt the seams of the product and seal with 3” wide poly tape. Note: Utilize a flat edge taping tool to assure good adhesion on all tape.

• Install Snow Melt System per manufacturer’s specifications.