Installation Guide

N24 LowesCan Revised 0915

TESTING & CERTIFICATIONS

• Thermal Performance ASTM C518

• Fungus Resistance Mil-Std 810B Method 508

• Pliability Test ASTM C1224

• Water Vapor Transmission ASTM E96

• Tensile Strength ASTM D751

MANUFACTURER’S SUGGESTED INSTALLATION INSTRUCTIONS

Note: Installation instructions and illustrated drawings are recommendations only,

while proper local construction methods are the responsibility of the installer.

RADIANT FLOOR OVER AN EXISTING FLOOR

• Unroll the Reflectix

Concrete Slab Insulation over the existing floor prior to pouring the concrete (white poly side facing up). Cut product flush with

the walls.

• Butt the seams of the product and seal with 3” wide poly tape. Note: Utilize a flat edge taping tool to assure good adhesion on all tape.

• Install Radiant Floor System per manufacturer’s specifications.

RADIANT FLOOR IN A CONCRETE SLAB

• Unroll the Reflectix

Concrete Slab Insulation product over the base material prior to pouring the concrete (white poly side facing up).

• Butt the seams of the product and seal with 3” wide poly tape. Note: Utilize a flat edge taping tool to assure good adhesion on all tape.

• Install Radiant Floor System per manufacturer’s specifications.

CONCRETE SLAB (SNOW MELT)

• Unroll the Reflectix

Concrete Slab Insulation product over the base material prior to pouring the concrete (white poly side facing up).

• Butt the seams of the product and seal with 3” wide poly tape. Note: Utilize a flat edge taping tool to assure good adhesion on all tape.

• Install Snow Melt System per manufacturer’s specifications.