User`s manual

ENGLISH
2322
STEP 1 – Powering on the scanner
STEP 2 – Select lm type
a. Open the CyberView X scanning interface.
b. Select the lm type to be scanned - Positive, Negative or B&W (Black and
White).
HOW TO SCAN
Status LED Scanner Status
Power on Cycle Unit will take approx. 40-50 sec. to callibrate. The power LED
will be solid green (not blinking) to indicate that the scanner
is ready to use.
Status LED - On solid Ready state.
Film holders can be inserted/removed
Blinks (on/o change) Scanner is busy, do not turn the unit o.
Insert/remove lm holders.
Flashes several times,
then a pause,
then ashes again
Scanner is malfunctioning. Turn the unit o, close the
software. After approx. 10 sec. power on the scanner, wait for
calibration, then re-open CyberView X.
c. Once you have selected a lm type you will have the option to select the
frame sizes for the various 120 format lms, after you have inserted the lm
holder into the unit.
NOTE: The 135 lm will be auto-detected, a frame selection is not necessary.