Operation Manual

ENGLISH
3
3
ENGLISH
2
2
TABLE OF CONTENTS
TABLE OF CONTENTS
Getting Started 4
Quick Installation Guide (QIG) 5
Installing Software and Driver 6
Installing Hardware 8
Additional Features 8
Loading the  lm/slides into the Holders 9
One Button Scan 11
How to Scan Slides 12
STEP 1 - Aquire Driver 12
STEP 2- Select Film Type 12
STEP 3 - Optional Prescan 12
STEP 4 - Set Scan Settings 13
STEP 5 - Set Scan Preferences 14
STEP 6 - Scan 17
STEP 7 - Exit 17
User Interface 18
I Main Window Area 18
II Preview Window Area 20
III Scan Setting Area 25
Technical Support 26
FEDERAL COMMUNICATIONS COMMISSION
FEDERAL COMMUNICATIONS COMMISSION
FCC STATEMENT
FCC STATEMENT
This Equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
•
• Re-orient or relocate the receiving antenna.
•
• Increase the separation between the equipment and receiver.
•
• Connect the equipment into an outlet on a circuit di erent fromwhich
the receiver is connected to.
•
• Consult the dealer or an experienced radio/TV technician for help.
Warning :
Use only shielded signal cables to connect I/O devices to this equipment.
You are cautioned that changes or modi cations not expressly approved by the
party responsible for compliance could void your authority to operate the
equipment.