User Manual-Dual litering

www.reflecmedia.com
Connecting the Dual LiteRing to the Dual LiteRing Controller
The LiteRing is fitted with a 3 pin XLR plug on the end of a flying lead. Insert this into the 3 pin XLR
socket on the LiteRing Controller, ensuring that the plug is latched to prevent accidental removal.
Always connect the LiteRing to the LiteRing Controller before connecting power or switching the
controller on.
Once connected, always stow any excess cable neatly.
If the 3 pin XLR plug or socket is damaged, return the unit to your Reflecmedia dealer for repair.
Powering the Dual LiteRing & Dual LiteRing Controller
The Dual LiteRing Controller is tolerant of a wide range of input voltages, from 7.5 to 12Vdc.
It is recommended for Studio use that the Reflecmedia 12V mains adapter (RM5224) is used to
provide power; this is provided in our LiteRing Kit’s.
The 12V mains adapter is fitted with a 4 pin XLR plug on the end of a flying lead.
Insert this into the 4 pin XLR socket on the LiteRing Controller side as shown, ensuring that the plug
is latched to prevent accidental removal.
Once connected, always stow any excess cable neatly.
3 pin XLR to LiteRing
For more freedom in use, the LiteRing Controller may be powered from a battery. This reduces the
number of cables needed and allows the unit to be more mobile and flexible.
Industry standard batteries of the Sony NP-F Mini DV pattern, as used on many Sony mini DV
cameras have been chosen.
The low power consumption of the LiteRing allows many hours of use between battery charges.
Ensure that your battery is fully charged and slide it into the battery mount fitted on the rear face of
the controller housing. Note that the battery needs to be pressed towards the mount whilst sliding
towards the battery holder contacts to allow the latch to engage.
4 pin XLR – DC power in