Owners manual

30127IN – 3/19/12 REV D PCN16947 ©2012 CEQUENT PERFORMANCE PRODUCTS, INC. Printed in CHINA 6
3. Place the REESE® Elite™ Series Gooseneck Hitch under the truck (As shown in figure 8) using the ¾”
carriage bolts (2) slide them into place through the openings in the rail kit.
4. Slide the gooseneck center section up around the bolts, place a washer and nut on the bolt. DO NOT
TIGHTEN THE HARDWARE AT THIS TIME.
5 . Once the REESE® Elite™ Series Gooseneck Hitch has been loosely assembled , locate the collar in the 3 ½” hole
that was cut. See Figure 7.
6. Once the top of the gooseneck receiver tube is located in the hole (See figure 9), then tighten the hardware to a
torque of 180 ft/lbs. It might be helpful to lower the spare tire to get extra room to swing the torque wrench.
Fig. 9
Fig. 8
Installed gooseneck in truck
bed.
Vehicle Forward
Vehicle Forward